home button menu

vRigger Learning Center

This also applies to cable, chain, and webbing.

Gear that is anchored includes anchors, rocks, trees, tripods, trucks, etc.

A "bight" is a simple loop in a rope that does not cross itself.

A "bend" is a knot that joins two ropes together. Bends can only be attached to the end of a rope.

A "hitch" is a type of knot that must be tied around another object.

"Descending devices" (e.g., ATCs, Brake Bar Racks, Figure 8s, Rescue 8s, etc) create friction as their primary purpose. The friction in descending devices is always considered when calculating forces.

The "Safety Factor" is the ratio between the gear's breaking strength and the maximum load applied to the gear (e.g., 5:1).

Wrap-3-Pull-2

Many anchors, including the pipe shown below, support a Wrap-3-pull-2 command. When the Wrap-3-Pull-2 command is selected, a segment of rope is drawn across the anchor.

To Wrap-3-Pull-2

First connect a rope to the item.

Then do one of the following:

  • Select the gear and then choose Wrap-3-pull-2 in the Attributes group on the Home toolbar.
Zoom Group
  • Right-click on the item and choose Wrap-3-Pull-2 from the shortcut menu.
Wrap-3-pull-2 command

If the Wrap-3-pull-2 is disabled on the toolbar (and isn't in the shortcut menu), it means the selected item doesn't support the Wrap-3-Pull-2 command. If there is gear in vRigger that you think should support the wrap-3-pull-2 command, please tell us!

Position a Knot on the Wrap

When building an anchor using the wrap-3-pull-2 technique, many riggers position the knot on the anchor so the knot won't weaken the webbing. It takes a little trickery to display the knot on the wrapped object:

  • Drop the webbing on the anchor (e.g., a pole).
  • Use the Wrap-3-pull-2 command to wrap the object.
  • Use a rope joiner to connect the ends of the webbing.
  • Manually place a water knot in the desired location. (Note that the water knot will not actually be connected to the webbing.) You may need to use the "Bring to Front" command to move the water knot in front of the anchor.
  • You may want to select the water knot and change its color in the properties pane.
  • A downloadable sample file explains these steps.

Tips

After using the Wrap-3-Pull-2 command, you may want to float the knot on the rope.

The Wrap-3-Pull-2 command is only available when chain, rope, or webbing is connected to an anchor that supports the Wrap-3-Pull-2 command. For example, a carabiner does not support the command, but trees, poles, etc do.

If you create your own gear using the Gear Builder, select the Can wrap-3-pull-2 checkbox if you want your gear to support the Wrap-3-Pull-2 command.